Instruction Manual
INSTRUCTION MANUAL
User Guide
Thank you very much for purchasing a product from Nendoroid Face Maker.
Please read the following instructions carefully before use, and handle the product properly.
Important Safety Instructions
(Please read before use)
- Keep out of reach of small children.
- To prevent suffocation accidents, please dispose of all plastic bags and packing materials immediately after opening.
- Small parts may pose a choking hazard. Do not put them in your mouth under any circumstances.
- Stop using the product immediately if it becomes damaged or deformed.
- Keep away from open flames.
- Do not leave the product in direct sunlight, near heating equipment, or in hot, humid, or dusty environments for extended periods of time.
- Applying excessive force may cause breakage.
- Be careful not to pinch your fingers or hands when attaching parts.
- Do not use the product for purposes other than its intended use.
About the Original Face
- Depending on the design of your Nendoroid figure, the plates may not fit properly.
- Attach the neck joint base part in the direction indicated by the arrow in the diagram below.
About the Nendoroid Hoodie
- The Nendoroid Hoodie can only be attached to Nendoroid figures whose upper and lower body parts can be separated.
- Depending on the design of your Nendoroid figure, the plates may not fit properly.
- The diameter of the bottom peg hole is approximately 4.5 mm.
Handling Parts That Don’t Fit Properly
If the face plates or body parts you ordered do not fit your Nendoroid correctly, please try the following methods.
Material Characteristics
The face and body parts are made of PVC material.
PVC becomes softer when warmed and contracts when cooled.
Using this property may help the parts fit together more easily.
Adjustment Methods
Without Heating
Align the protruding section of the face plates with the recessed section of the back-head part, and carefully press them together while gently widening the gap.
With Heating
Use a hair dryer (set to medium heat) to gently warm the parts.
As the material softens, attachment may become smoother.
Do not apply high heat directly or for long periods—warm the parts gradually while checking their condition.
- PVC will not melt or deform unless exposed to extreme heat, so please feel free to try this method safely.
- For more tips, check out the “Nendoroid Troubleshooting Room” on GOOD SMILE CHANNEL (YouTube).
- If the issue persists after trying the above methods, please contact us via the Contact Form.
